Electronic PCB Prototypes For Camera Module

Electronic PCB Prototypes For Camera Module

Electronic PCB Prototypes For Camera Module is made of fiberglass reinforced plastic with copper wire tracks instead of wires. By drilling the holes in the plate, the components are then soldered into place to hold the components in place. Copper tracks connect the components together to form an electrical circuit.

Product Details

Product introduction:

1. Electronic PCB Prototypes For Camera Module is made of fiberglass reinforced plastic with copper wire tracks instead of wires. By drilling the holes in the plate, the components are then soldered into place to hold the components in place. Copper tracks connect the components together to form an electrical circuit.

2. The FR-4 material used in it provides the basic standard for PCB substrates. This material achieves a broad and effective balance between cost, manufacturability, electrical performance, durability and performance. It provides lower dielectric loss, low signal loss, and low cost circuit fabrication.

3. Electronic PCB Prototypes For Camera Module is a self-contained circuit board with interconnected electrical and electronic components. The circuit is produced by a layer of slightly conductive material deposited on the outside of an insulating plate called a substrate. Separate components are located on the surface of the substrate and soldered to the connected circuitry. In the hole technique of Electronic PCB Prototypes For Camera Module, each component consists of thin leads that are pressed through a small hole in the substrate and soldered to the connection plate in the back circuit.

Specifications:

parameter.png

Previous:Smart Home Pcba Next:Fr4 Material Pcb Assembly

Inquiry